I had no idea there was a tool designed to help you hem pants. I'd always worn them to measure how much material needed to be cut and hemmed for the pants to fit right, remeasured after taking off the pants, pinned the line, drawn a line to cut on, cut the excess, then measured, pinned, invariably pinned the wrong side of my pants, pinned again, turned under the hem and pinned one last time. Finally, the easy part: sewing. After an hour or more my pants would be hemmed and I'd be annoyed enough that I'd avoid hemming another pair for as long as I could.
But I was looking at sewing notions a few days ago and came across this: it's called a sewing and knitting gauge and it cost $1.20.
And I just happened to have a pair of pants ready to be hemmed. I put the pants on and pinned up the sides, so I knew where to begin, then I got out my new tool. There's a plastic slier you put to the measurement you want, then you stick it inside the groove and make sure the fabric is the same height all around using that measurement. It was very fast and required no pins.I then decided where to cut for the hem, and used the measurements on the side of the tool to mark a pencil line for cutting.
After cutting, it was again easy to set the hem line, then turn down and pin the fabric. This is the second point where pins were needed, rather than the third or fourth.
In a fraction of the time it would normally take me to hem pants, these were done!
